Hi,
If you do not see a Contents Menu on the left side of this page, Please click HERE for this site to load properly.
Thank you for visiting my S10 conversion site.
Here it is!!
Aug 29, 2007...OUT with the OLD!
Remove Clutch petal, reservoir, clutch master cyl., and clutch Slave cylinder.
I Plug the hole in the transmission housing with Foam pipe insulation.
I also removed the fuel tank and then pulled the fuel lines towards the rear of the truck out of the frame.
I will save the 3/8" fuel line to use for the vacuum lines needed for the 12 Volt brake vacuum pump.
Aug. 28, 2008
The conversion is pretty well complete.
It is time to get this mess cleaned up.
I loaded all of the stuff that I had removed from the S10 conversion into the truck.
I took all of the stuff to Pacific Recycling and Steel in the newly converted S-10 EV.
I sold 420 LBS. and received $10.50 in cash.
Next Building the S-10 Tilt Bed.